Nabíjecí kabely & adaptéry

Battery level indicator - SAE - std/wet cell

OptiMate Lithium 4S ampmatic, 12.8V- 9AHighly efficient diagnostic charger and tester for LiFePO4/LFP batteries. Perfect for charging a high-performance 12,8/13,2 V LiFePO4/LFP battery with a capacity of 2,5 to 120 Ah.Special features: The TUNE mode delivers stable power to reprogram a vehicle system, demonstrate a showroom model or to preserve the stored settings when the battery cables are disconnected to connect accessories or to replace the battery.BMS RECOVERY, activated with push button – for batteries with restart for protection against low voltage/complete discharge.SAVE mode with BMS recovery: starts from 0,5 V with continuous checking/testing of charge acceptance or bad/short-circuited cell condition. Unnecessary (and unsafe) charging of a bad battery is prevented.SafeTº: Automatic adjustment of the charging rate to the ambient temperature measured at the charger. Slower charging below freezing, no charging at temperatures below -20 °C / -4 °F (this can damage the lithium batteries).Ampmatic: the microprocessor matches the charging current for the ideal LiFePO4 charging curve to the size/condition of the battery, for the fastest and most complete way of charging.Specifications: CHARGING AMPS: 9,5 A (AmpMatic)USE: Indoor/outdoor (lowest temperature: -4 °F / -20 °C).RECOVERY: Starts from a low voltage of 0,5 V and 3-step RECOVERY and TEST at low voltage.IDEAL FOR: LiFePO4 (LFP) batteries with 4 cells between 2-120 Ah.INPUT: Universal (100-240 V 50-60 Hz), high efficiency (CEC-listed), fully sealed.STYLE: Weatherproof housing with wall mounts, a 5 ft/152 cm AC cable and a 6 ft/180 cm charging cable ending in an SAE connector.Weatherproof battery cable and standard set with battery clamps included.SAFE: No risk of overcharging. Completely safe for vehicle electronics. Sparks are suppressed. Safe long-term battery maintenance. Automatic shut-off in the event of a short circuit or when the battery is disconnected. 3-year limited replacement warranty.

Cable with battery clamps - KETLength : 6ft / 180cmTM/KET

The most TRUSTED battery charger in racing! The OptiMate 3, the all-in-one tool for maintaining your 12V battery at home. Diagnosis, recovery, charging, tests and optimal maintenance are carried out automatically. This latest version of the OptiMate 3 offers all the user-friendly features of the more than two million OptiMates produced since 1995, but is now lighter and more efficient than ever. The OptiMate 3 desulfates batteries and then tests them after charging. The maintenance program delivers only what the battery needs, without ever overcharging or undercharging it.CHARGING CURRENT: 0,8 A (constant current)USE: Indoor/outdoor (lowest temperature: -4 °F/-20 °C).RECOVERY: Starts from a low voltage of 2 V and two-phase desulfation recovery.IDEAL FOR: 12 V STD, AGM and GEL batteries between 3 – 50 AhINPUT CURRENT: Universal (100-240 V 50-60 Hz), high efficiency (CEC-listed), fully sealed.DESIGN: Weatherproof housing with wall mounts, a 6 ft/180 cm AC cable and a 6 ft/180 cm charging cable ending in an SAE connector. Weatherproof battery cable and standard set with battery clamps included.SAFE: No risk of overcharging. Completely safe for vehicle electronics. Sparks are suppressed. Safe long-term battery maintenance. Automatic shut-off in the event of a short circuit or when the battery is disconnected. 3-year limited replacement warranty.

OptiMate Solar DUO + 40W Solar Panel6-step 12V / 12.8V 3.33A sealed solar battery-saving charger & trickle chargerCHARGESaves flat batteries from as low as 4 volts thanks to its unique pulse action. Fastest way of charging – thanks to the ‘smart charge’ control that selects pulse charge or continuous charge according to the strength of the sunlight. Intelligent maintenance – continues the next day if the battery retained the charge overnight; if not, the program reverts to the OPTIMIZE step.MONITORBattery status is displayed every 3 seconds. Ready indication for STD and hi-performance AGM batteries and Lithium LFP batteries. Draws less than 0,5mA during monitor mode. Automatically switches to CHARGE when there is sufficient solar energy.MOUNTINGThe OptiMate charge controller is separate from the panel and can be placed close to the vehicle or the battery, so that the charging progress and the maintenance of the battery can be easily followed. The solar panel must be mounted so that it receives direct sunlight. The reach/distance between battery and panel is 315 cm/124?. Use the OptiMate extension cables O-03, O-13 or O-23 to connect the solar panel to the OptiMate charge controller over a longer distance.Outer dimension, including corner mounting brackets: Width = 42 cm / 16.6 ” Height = 68.6 cm / 27 ” Depth = 3.3 cm / 1 1/4 ” Solar panel:POWER : 40 Watts (max.)VOLTS : 12V / 12.8VUSE : Outdoor / indoor.STYLE : Weatherproof, aluminium frame with 4 mounting brackets, output cable 200 cm / 80? with SAE connector.OptiMate charge monitor:CHARGING AMPS : 3.33A from 40W panel (max. average current), 3-5A pulse currentUSE : Indoor / outdoor (lowest temperature: -4 °F / -20 °C).SAVE : starts from a low voltage of 4VIDEAL FOR : 12V STD, AGM and GEL batteries from 2 – 240 Ah and 12,8V/13,2V lithium LFP batteriesINPUT : 15 – 22VSTYLE : Weatherproof charge monitor housing.INCLUDED: Weatherproof battery cable, standard set of battery clamps & 40W solar panelSAFE: No risk of overcharging. Completely safe for vehicle electronics. Sparks are suppressed. Safe long-term battery maintenance. Automatic shut-off in the event of a short circuit or when the battery is disconnected.WARRANTY: 3-year limited replacement warranty.

10 Amp battery charging cable extender with weather-/dirt-resistant SAE connection system.Long, black extender for cars and marine applications.Specifications:- Length: 762 cm- Connectors: SAE to SAE- Cable class: 16AWG (1,31mm²) SPT2-W- Use: -40°C/-40°F for use at low temperatures- Design: Includes in-line rubber seal for OptiMate heavy-duty SAE connector

The SPI1 battery charger has a maximum charging current of 1 amp. The charger works on 230V AC and charges 6V and 12V DC batteries. Thanks to the hook, the charger is easy to store during charging, so that the cables are not in the way. In addition, this trickle charger is fitted with a rubber housing to protect it even better against impact and drop damage.Specifications:• Voltage: 6V DC - 12V DC• Min. battery voltage: 0,5V• Max. charging current: 1A• Suitable for: AGM, GEL, CALCIUM, Start 'n Stop• Rubber housing• Microprocessor• Protection against reverse polarity• Thermal protection• Automatic shut-off• Hook• IP54

with double NATO 24V plug & red auxiliary connector

The SPI2 battery charger has a maximum charging current of 2 amperes. The charger runs on 230V AC and charges 6V and 12V DC batteries. Thanks to the hook, the charger is easy to store while charging, so the cables don't get in the way. In addition, this trickle charger has a rubber housing to protect it even better against impact and drop damage. Specifications: • Voltage: 6V DC - 12V DC • Min. battery voltage: 0,5V • Max. charging current: 2A • Suitable for: AGM, GEL, CALCIUM, Start 'n Stop • Rubber housing • Microprocessor • Protection against reverse polarity • Thermal protection • Automatic shut-off • Hook • IP54

The SPI15 battery charger has a maximum charging current of 15 amperes. The charger runs on 230V AC and charges 12V DC batteries. Thanks to the hook, the charger is easy to store while charging, so the cables don't get in the way. In addition, this trickle charger has a rubber housing to protect it even better against impact and drop damage. The charger is equipped with a showroom mode that provides a constant power supply. Specifications: • Voltage: 12V DC • Min. battery voltage: 0,5V • Max. charging current: 15A • Showroom mode • Suitable for: AGM, GEL, CALCIUM, Start 'n Stop • Rubber housing • Microprocessor • Protection against reverse polarity • Thermal protection • Automatic shut-off • Hook • IP20

The SPI6 battery charger has a maximum charging current of 6 amperes. The charger runs on 230V AC and charges 12V DC batteries. Thanks to the hook, the charger is easy to store while charging, so the cables don't get in the way. In addition, this trickle charger has a rubber housing to protect it better against impact and drop damage. Specifications: • Voltage: 12V DC • Min. battery voltage: 0,5V • Max. charging current: 6A• For batteries up to 130Ah• Suitable for: AGM, GEL, CALCIUM, Start 'n Stop • Rubber housing • Microprocessor • Protection against reverse polarity • Thermal protection • Automatic shut-off • Hook • IP20

The SPI3 battery charger has a maximum charging current of 3 amperes. The charger runs on 230V AC and charges 12V DC batteries. Thanks to the hook, the charger is easy to store while charging, so the cables don't get in the way. In addition, this trickle charger has a rubber housing to protect it even better against impact and drop damage.Specifications:• Voltage: 12V DC• Max. charging current: 3A• Suitable for: AGM, GEL, CALCIUM, Start 'n Stop & Lithium LiFePO4• Rubber housing• Microprocessor• Protection against reverse polarity• Thermal protection• Automatic shut-off• Hook• IP54

This battery charger for 12V batteries delivers a continuous and stable power supply of up to 60 amperes. The charger is equipped with a microprocessor and has a 2,5m cable.Performance characteristics:• Voltage: 12V• Input voltage: 110-240V - 50-60Hz • Current: 60A• Input power: 1100W• Charging current: 5-60A• Charging capacity: 5-600Ah• Maintenance capacity: 5-1800AhTechnical characteristics:• Cable: 2,5m• Microprocessor• Application: reprogramming, flashing & diagnostics of cars• Selectable output voltage 14,8V• Protection against reverse polarity and short circuit• Protection against overload and voltage faults• Permanent and stable current• Robust clamps*Suitable for AGM, WET, Lithium LiFePO4

with MAN 24V plug & grey auxiliairy connector

with CATERPILLAR 24V plug & red auxiliairy connector

with NATO 24V plug & grey auxiliairy connector

CABLE 2M/70MM²/ RED CONNECTOR + PARK PLUG CONNECTOR

The SPI10 battery charger has a maximum charging current of 10 amperes. The charger runs on 230V AC and charges 12V DC batteries. Thanks to the hook, the charger is easy to store while charging, so the cables don't get in the way. In addition, this trickle charger has a rubber housing to protect it even better against impact and drop damage. Specifications: • Voltage: 12V DC • Min. battery voltage: 0,5V • Max. charging current: 10A • Suitable for: AGM, GEL, CALCIUM, Start 'n Stop • Rubber housing • Microprocessor • Protection against reverse polarity • Thermal protection • Automatic shut-off • Hook • IP20

Fit a connector on all your vehicles and machines to make their batteries accessible at any time; essential for fleets of vehicles which regularly require restarting.

The SPI1224 battery charger has a maximum charging current of 15 amperes at 12V and 10 amperes at 24V. The charger runs on 230V AC and charges 12-24V DC batteries. Thanks to the hook, the charger is easy to store while charging, so the cables don't get in the way. In addition, this trickle charger has a rubber housing to protect it even better against impact and drop damage.Specifications:• Voltage: 12-24V DC• Min. battery voltage: 0,5V• Max. charging current: 15A - 10A• Suitable for: AGM, GEL, CALCIUM, Start 'n Stop• Rubber housing• Microprocessor• Protection against reverse polarity• Thermal protection• Automatic shut-off• Hook• IP20

with 'PARK plug' & auxiliairy grey connector2 m x 70 mm² jump cable fitted with a NATO aviation plug with 3 contacts for connection to aircraft or helicopters of 12V, 24V or with 28V turbine.

with NATO 24V plug & grey auxiliairy connector

This battery charger for 12V batteries delivers a continuous and stable power supply of up to 100 amperes. The charger is equipped with a microprocessor and has a 6m cable.Performance characteristics:• Voltage: 12V• Input voltage: 110-240V - 50-60Hz • Current: 100A• Input power: 1700W• Charging current: 10-100A• Charging capacity: 10-1000Ah• Maintenance capacity: 10-3000AhTechnical characteristics:• Cable: 6m• Microprocessor• Application: reprogramming, flashing & diagnosis of cars• Selectable output voltage 14.8V• Protection against reverse polarity and short circuit• Protection against overload and voltage faults• Permanent and stable current• Robust clamps*Suitable for AGM, WET, Lithium LiFePO4

with double NATO 24V plug & grey auxiliary connector